To protect your car before winter, wash it, decontaminate it and apply a protection to the clear coat before the first road salting. Depending on your car and your budget, this protection ranges from a ceramic shampoo at 21.90 € to a PPF on the front from 1 790 € incl. VAT, by way of a 3-year ceramic coating from 1 230 € incl. VAT, polishing included.
Every winter, cars arrive at the Wavre workshop with white deposits on the sills and chips on the bonnet. Here is what salt, grit and mud do to bodywork, and the three levels of protection we offer, with their prices.
What winter does to bodywork
Road salt holds moisture against the metal. It builds up in the wheel arches, on the sills, on the wheels and in the door seals. On a paint chip that is already there, it reaches the metal and rust starts. On intact clear coat, it leaves white marks that set if the car dries without rinsing.
The grit spread with the salt is thrown up by the tyres of the vehicles ahead of you. It hits the front bumper, the bonnet, the mirrors and the bottom of the doors. Each impact leaves a spot in the clear coat, sometimes down to the metal.
Mud is abrasive. Rubbed dry with a mitt or a cloth, it scratches the clear coat. The cold adds its share: hot water on frozen bodywork causes thermal shock, and water left in the locks and the seals freezes.
Level 1: wash more often, and differently
Rinse before touching the bodywork. A high-pressure jet, from the bottom up, removes the salt and sand that would scratch under the mitt. Concentrate on the wheel arches and the sills. Then wash with two buckets, a clean mitt and a neutral shampoo or a ceramic shampoo, then dry with a microfibre.
Avoid roller car washes: brushes loaded with sand from the previous cars scratch the clear coat. Do not wash below 0 °C. After each episode of salt, a rinse is enough if you do not have time for a full wash. The instructions we give to PPF owners apply to every car: read maintaining a PPF: washing, products, mistakes.
Level 2: ceramic coating, so that salt does not stick
A ceramic coating lays down a hard, hydrophobic layer on the clear coat. Water beads, salt and mud hold less, washing takes less time and the clear coat is protected from chemicals and UV. A ceramic coating does not stop stone chips: an impact goes through the layer and marks the clear coat.
On a car in use, we do not apply a ceramic coating without polishing. The layer locks in the condition of the paint for 3 years: wash swirls have to go first. Our prices for polishing and a 3-year ceramic coating:
| Vehicle size | Polishing and 3-year ceramic coating, incl. VAT |
|---|---|
| City car | 1 230 € |
| Compact and saloon | 1 340 € |
| Estate and SUV | 1 430 € |
| Large SUV, MPV, van | 1 570 € |
For a new city car with less than 3,000 km, an entry-level protection exists from 350 €: a lighter product, which lasts one year at most. The details are on our page about ceramic coating and the polishing levels on our page about polishing.
Level 3: PPF, for stone chips
A PPF is a polyurethane sheet of about 200 microns bonded to the clear coat. It absorbs stone chip impacts and rubbing. Its top layer closes over micro-scratches with heat. The front of the car takes most of the projections: bumper, bonnet, front wings and mirrors make up the front end, from 1 790 € incl. VAT for a city car. A full vehicle in gloss film, with ceramic coating on wheels and glass, starts at 4 690 € incl. VAT.
The film is installed on polished and decontaminated paint, in the workshop. The details of the packages are on our page about paint protection film (PPF). All the protections we install are compared on our page about protections.
The wheels and the sills, forgotten every winter
Brake dust settles on the wheels and mixes with the salt. Iron particles embed themselves in the wheels' clear coat and leave rust spots. An iron remover dissolves them: spray onto a cold wheel, leave it to work until the colour changes, rinse. A wheel ceramic coating, applied to a clean, dry wheel, then stops deposits from sticking and reduces washing to a rinse.
Also rinse the wheel arches and the underside of the sills at every wash. Salt stays there for weeks if nobody removes it.
In the shop
- Nano Carapace Nano Wash & Pearl, ceramic shampoo 500 ml, 21.90 € incl. VAT: washes and leaves a hydrophobic layer at every wash.
- Nano Carapace Rims Ferious, iron remover 500 ml, 17.50 € incl. VAT: dissolves iron particles on the wheels and the bodywork.
- Nano Carapace Rims Protect, ceramic coating for wheels, 60 € incl. VAT: to be applied to clean, dry wheels before the first road salting.
When to do it
Before the first road salting, so in November. Polishing and a ceramic coating need a clean car and a visit to the workshop: book your slot in advance. If winter has already started, a careful wash, a decontamination and a ceramic coating remain possible all year round, since the application is done in the workshop.
Frequently asked questions
Can a ceramic coating be applied in the middle of winter?
Yes. The application is done in the workshop, on polished and degreased paint. We do it all year round.
Does salt damage a ceramic coating or a PPF?
Rinsed within a few days, no. A ceramic coating resists chemicals and film is washed like paint. Salt left for weeks without rinsing leaves marks on any surface.
Do you have to polish before a ceramic coating?
On a car in use, yes. On a new city car with less than 3,000 km, an entry-level protection from 350 € is applied without polishing.
Is a roller car wash in winter a problem?
The roller brushes hold the sand from the previous cars and scratch the clear coat at every pass. Prefer a manual high-pressure jet followed by a two-bucket wash.
How much does protection before winter cost?
A ceramic shampoo costs 21.90 € incl. VAT, a wheel ceramic coating 60 € incl. VAT. Polishing with a 3-year ceramic coating starts at 1 230 € incl. VAT, a PPF on the front end at 1 790 € incl. VAT.
Nathan Fougnies, founder of Ultimate Care, Wavre